Select decking boards with the preservative concentration suitable for their use. Wood used in situations where it's more likely to rot contains more preservative. The three common ratings: Above-grade use (.25, sometimes .15). Typically used for decking, fence and railing material. Ground-contact use (.40).
Home / Products / Building Supplies / Decking and Fencing / Pressure Treated Wood / Treated Wood Green - 5/4 in x 6 in x 16 ft [Product page top promo box] Product selection from SELECT
Attach that rail to the fence posts by placing two No. 8 galvanized 2 1/2-inch deck screws through each end of the rails and into the post. 4 Measure and cut the remaining lower rails.
Notice how the balusters are 5/4"X2-1/2" rectangle shape and are set into the railing in sets or triplets. Who says you can't make a wood rail look contemporary and stylish? You can also let each post to protrude above the top rail as seen in this composite railing system with lighted post caps.
What are your thoughs on 5/4 vs 1" deck boards. 16" centres but am concerned the 1" boards could end up being a bit bouncy. ... So a 4/4 x 8" board is really a 3/4" x ...
Treated Boards, Decking, Lumber & Timbers. ... Fence Rail (1) Fire Retardant Dimension (4) Pressure Treated Board (24) Pressure Treated Center Match (7)
Building a 4 rail fence and need some help please.. Yesterday I bought 20 treated 4x4x8's at Lowes for $5.97 per. I looked at the 16' runs of 5\4 boards which are listed as deck boards and they ar $15 a peice!!!!!!!!
I want to put up some more board fence, but rough-cut is really a PITA to deal with. I can get 1x6 treated poplar fence boards, but treated 5/4 decking is cheaper, as well as being thicker. Any thoughts?
This horizontal Slipfence system also allows for adjustments in the boards if they should shrink over time, keeping the fence fully private. Inside channel width 1-1/8 in. to accommodate a 5/4 in. deck board with an actual thickness of 1 in. Kit includes 2-channels 70.5 in. L
5/4 in. x 6 in. x 8 ft. Standard Ground Contact Pressure-Treated Pine Decking Board is rated 4.1 out of 5 by 80. Rated 5 out of 5 by HomeDepotCustomer from This was a great pressure treated plank to repair my...
Space the rails evenly from top to bottom, but be sure that the bottom rail clears the ground by at least 4 inches to forestall rot and allow for easy mowing. After the fence is up, take a well-deserved break.
Horizontal fence rails are typically full 1 inch thick by 6 inch wide lumber but can be conventional 2 x 6 lumber as purchased from a big box store. Normal finished height is 48 inches, but a 4 board “post and rail” fence can be stretched up to 5 ft. tall without it looking odd.
If it is not possible to shorten the spans than you can substitute the 1″ x 6″ with 5/4″ deck boards. The 5/4″ boards will be stronger and should be more stable. There may still be some sagging, depending on the length of the horizontal span.
The three main components of design plan for deck fencing or porch railings are the support posts, balusters, and rails. Support posts are an important feature of the deck because they are the sturdiest component of the fence.
This fence panel is made from 1×4×42” or 48” Appearance Grade fence boards that are fastened with ring shanked nails to 5/4×4×8 back rails. Panels consist of 16 fence boards with 2 back rails.